This was sent to me by one of our old sponsors, and I’ve only just got
round to having a little play with it. So this isn’t going to be a full
review, but more of a ‘quick look around’ the Tinker, and a few thoughts
on the mod.
Thanks to Vapesourcing for your sponsorship over the last 12 months, and this is the Wismec Tinker.
Initial Thoughts On The Wismec Tinker
the Tinker is a triple 18650 battery mod, that can reach 300w! The last
triple battery mod I owned was the very first Realeaux… I took it out
of the box, popped the batteries in, took them back out, put it back in
the box and sold it! The weight of 3 batteries in a mod just isn’t for
me, and it wasn’t comfy to hold either.
So the Tinker is inspired by a classic Nike sport shoe! What the?…..
A huge shout out to Vapesourcing.com for sending me the Sinuous V80 from
Wismec to have a little looky at. I had a Sinuous P80 a couple of years
ago, one of the first ones they did and it was a decent little device,
in fact it accompanied me to Florida on holiday and it did great. So
lets see how the V80compares….
Wismec Sinuous V80 Specs
Size: 27mm * 34mm * 81mm Output wattage: 1-80W Cell type: high-rate 18650 cell (discharging current should be above 25A) Output mode: VW/Bypass/TC-Ni/TC-Ti/TC-SS/TCR mode Resistance range: 0.05-1.5ohm for TC modes 0.05-3.5ohm for VW mode Temperature range: 100-315℃/200-600℉(TC modes) Maximum charging current: 2A Output voltage range: 0.5-9V Thread type: 510 spring loaded connector Amor NSE Tank Diameter: 26mm Height: 46mm E-liquid capacity: 3ml
In The Box:
1x WISMEC SINUOUS V80 MOD (no cell) 1x Amor NSE Atomizer 1x WS04 MTL 1.3ohm Head 1x WS-M 0.27ohm head (pre-installed) 1x QC USB Cable 2x User Manual 2x Warning Card Spare part
Initial Thoughts on the Wismec Sinuous Kit
Sinuous kit comes well packaged, and looks really cool when you take
the lid off the box. I got a green one, and its not a bad looking little
kit. Removing it from the box, and you can tell that it’s a budget
device. It’s made from some kind of plastic, and what looks like
aluminium top plate and battery cover. This of course means that the mod
is extremely light, even after you have a popped a battery in.
This was sent to me by Vapesourcing.com for the purpose of this review so a huge shout out and thanks to them
The Luxotic MF is a bit of an all rounder in the vaping world, it can be a single battery squonk mod, or a dual battery VW wattage/temp control mod. The big feature with the mod is that you can change the 100w board for a direct output board that makes it run like a mech mod. This can be used in either dual battery configuration or single battery squonk configuration… The confusing thing seems to be, why add the direct output board when you can run the 100w chip in bypass mode?
So on opening the box you’re met with a whole array of spare parts, the mod, the direct output board. The guillotine 2 RDA, which I’m actually not going to do a full review on, although I will give a few thoughts on this.
Thanks to Vapesoursing.com for sending out the Wismec Hiflask for me to try, another pod type starter kit. With a couple of noticeable differences that you don’t normally get with pod type kits. First it has a catch to release the pod, and it alo has air flow control!
Wismec Hiflask Specs
Size: 48.6 x 28.2 x 89.0mm(drip tip included)
Liquid Capacity: 5.6ml
Battery Capacity: 2100mAh
Maximum Charging Current: 2A
Output Mode: Direct output
In The Box
1 x HiFlask Battery
1 x HiFlask Cartridge
2 x JVUA 0.35ohm Head
1 x QC USB Cable
1 x User Manual
1 x Set of Spare Parts
First thoughts are, it’s lightweight, very lightweight, in fact it doesn’t feel like there’s a battery inside! The design is nice, comfy in the hand. The shape is (kind of weird) slightly thicker on one end, which does fit the hand quite well.
It has the Wismec Logo one side, and Hiflask on the other, but neither logo’s are in your face like Wismec have done on some of their mods, this is more discreet so will suit some people better. Continue reading “Wismec Hiflask Review”
It seems that a lot of companies are jumping on the ‘squonk wagon’ right now and why should Wismec be any different! Now they’ve had their fair share of cracking devices (some that have developed problems with the 510, or in my case sticky buttons) but they have had some pretty good innovative designs over the last few years. And it always seems one step better when it has Jaybo’s name on it.
So onto the Wismec Luxotic specs:
Thread type: 510 spring loaded connector
Cell type: high-rate 18650 cell
Max output wattage: 100W
Tobhino BF RDA
In the box:
1 * LUXOTIC BF BOX
1 * Tobhino BF RDA
1 * E-liquid Bottle
2 * Clapton Coil
1 * Cotton
1 * 810 Top Cap
2 * User Manual
1 * Warning Card
I didn’t have to open the box as there is a clear front panel, but my initial thoughts were on the size, its small and cute! Tom sent me the green honeycomb design Luxotic which I’m actually quite pleased about, lots of mods have the resin finish at the moment and it was rather nice to get something different.